This is part of a series showing how to create polymer clay letter canes. (These alphabet cane tutorials were first published on my other website (KayVincent.com), but now I’m moving all of my polymer clay-related posts over to the PolymerKay site instead.) This Letter H Polymer Clay Alphabet Cane Tutorial is quite a simple and satisfying cane to create: you just need to cut three straight lines and fill them with black clay.
UPDATE (April 2024): Depending on your preferred learning style, there are now three ways to view the tutorial:
- video
- full step-by-step written and illustrated guide
- handy one-page summary.
(The order of instructions may differ slightly from each other, but the end result is the same.)
Letter H polymer clay alphabet cane tutorial
You will need
- About 30g white clay (approximately half a standard-sized block of clay)
- Approx. 8g black clay (about an eighth of a standard block)
- Pasta machine (5 things to look for when buying pasta machines for polymer clay)
- Tissue blade or clay slicer
Step-by-step instructions: Letter “H” alphabet cane tutorial
Step 0: Condition the clay (e.g. by rolling each colour through the pasta machine at least ten times, until they are soft enough to work with). (Here is an article about how and why clay should be conditioned.)
1: Roll the black clay into a sheet about 1.5mm thick (usually the middle setting of a pasta machine):
2: Roll the white clay into a cylinder about 25mm (1 inch) in diameter:
3: Slice off about a third of the white cylinder and save it for later:
4: Cut off the left and right sides of the cylinder (about a quarter of the way in from each side):
5: Add one layer of the black sheet of clay to the flat sides of the cane (and trim off any excess black):
6: Cut a horizontal line through the cane.
7: insert a piece of the black sheet of clay between the two pieces of white. (Trim off any excess black.)
8: Reassemble the cane.
9: Using the white piece of clay that was cut off in Step 3, roll it through the pasta machine on the thinnest setting and then wrap thin white layers around the sides of the cane:
10: Reduce the cane (e.g. by carefully rolling it on a flat surface until it becomes longer and thinner).
Finished Letter H polymer clay alphabet cane:
Here is the TikTok video tutorial:
…and finally, here is a handy graphic that shows the main steps all on one page.
Thanks for reading – I hope you found this letter “H” tutorial useful. If you’ve tried making any of these canes I’d love to hear from you – please share any successes (or problems) via the comments section or contact us page. Please also consider supporting me via the Ko-fi button below, which allows people to contribute to my polymer clay stash so I can keep creating these free tutorials for you.